Rainbow-electronics AT29LV010A Bedienungsanleitung

1Features• Single Supply Voltage, Range 3V to 3.6V• 3-volt Only Read and Write Operation• Software Protected Programming• Fast Read Access Time - 120

10AT29LV010A0520D–FLASH–05/02Notes: 1. These parameters are characterized and not 100% tested.2. See tOEspec in AC Read Characteristics.Data Polling W

11AT29LV010A0520D–FLASH–05/02Software Product Identification Entry(1)Software Product Identification Exit(1)Notes: 1. Data Format: I/O7 - I/O0 (Hex);A

12AT29LV010A0520D–FLASH–05/02Ordering InformationtACC(ns)ICC(mA)Ordering Code Package Operation RangeActive Standby120 15 0.04 AT29LV010A-12JCAT29LV01

13AT29LV010A0520D–FLASH–05/02Packaging Information32J–PLCCDRAWING NO.REV. 2325 Orchard Parkway San Jose, CA 95131RTITLE32J, 32-lead, Plastic J-le

14AT29LV010A0520D–FLASH–05/0232T – TSOP 2325 Orchard Parkway San Jose, CA 95131TITLEDRAWING NO.RREV. 32T, 32-lead (8 x 20 mm Package) Plastic Thin

Printed on recycled paper.© Atmel Corporation 2002.Atmel Corporation makes no warranty for the use of its products, other than those expressly contain

2AT29LV010A0520D–FLASH–05/02To allow for simple in-system reprogrammability, the AT29LV010A does not require highinput voltages for programming. Three

3AT29LV010A0520D–FLASH–05/02After the software data protection’s 3-byte command code is given, a byte load is per-formed by applying a low pulse on th

4AT29LV010A0520D–FLASH–05/02OPTIONAL CHIP ERASE MODE: The entire device can be erased by using a 6-bytesoftware code. Please see Software Chip Erase a

5AT29LV010A0520D–FLASH–05/02Notes: 1. After power is applied and VCCis at the minimum specified data sheet value, the system should wait 20 ms before

6AT29LV010A0520D–FLASH–05/02AC Read Waveforms(1)(2)(3)(4)Notes: 1. CE may be delayed up to tACC-tCEafter the address transition without impact on tACC

7AT29LV010A0520D–FLASH–05/02Input Test Waveforms and Measurement LevelOutput Test LoadNote: 1. These parameters are characterized and not 100% tested.

8AT29LV010A0520D–FLASH–05/02AC Byte Load Waveforms(1)(2)WE ControlledCEControlledAC Byte Load CharacteristicsSymbol Parameter Min Max UnitstAS,tOESAdd

9AT29LV010A0520D–FLASH–05/02Software Protected Program WaveformNotes: 1. OE must be high when WE and CE are both low.2. A7 through A16 must specify th