Rainbow-electronics DS1673 Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Computerhardware Rainbow-electronics DS1673 herunter. Rainbow Electronics DS1673 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 18
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
1 of 18 122800
FEATURES
Provides Real Time Clock:
Counts seconds, minutes, hours, date of
the month, month, day of the week, and
year with leap year compensation valid up
to 2100
Power control circuitry supports system
power on from day/time alarm
Microprocessor monitor:
Halts microprocessor during power-fail
Automatically restarts microprocessor
after power failure
Monitors pushbutton for external override
Halts and resets an out of control
microprocessor
NV RAM control:
Automatic battery backup and write
protection to external SRAM
3-channel, 8-bit analog-to-digital converter
Simple 3-wire interface
+3.0 or +5.0V operation
PIN ASSIGNMENT
Package Dimension Information can be found at:
http://www.dalsemi.com/datasheets/mechdwg.html
ORDERING INFORMATION
DS1673E - X 20-Pin TSSOP
DS1673S - X 20-Pin SOIC
3 +3V operation
5 +5V operation
DESCRIPTION
The Portable System Controller is a circuit, which incorporates many of the functions necessary for low
power portable products integrated into one chip. The DS1673 provides a Real Time Clock, NV RAM
controller, microprocessor monitor, and a 3-channel, 8-bit analog-to-digital converter. Communication
with the DS1673 is established through a simple 3-wire interface.
The Real Time Clock (RTC) provides seconds, minutes, hours, day, date, month, and year information
with leap year compensation. The RTC also provides an alarm interrupt. This interrupt works when the
DS1673 is powered by the system power supply or when in battery backup operation so the alarm can be
used to wake up a system that is powered down.
DS1673
Portable System Controlle
r
www.dalsemi.com
V
BAT
V
CCO
SCLK
I/O
CS
CEI
CEOL
CEOH
INT
GND
20-Pin TSSOP (4.4mm)
20-Pin SOIC (300 mil)
ST
V
CC
X1
X2
A
IN0
A
IN1
A
IN2
RST
BLE
BHE
20
19
18
17
16
15
14
13
12
11
1
2
3
4
5
6
7
8
9
10
Seitenansicht 0
1 2 3 4 5 6 ... 17 18

Inhaltsverzeichnis

Seite 1 - Portable System Controlle

1 of 18 122800FEATURES Provides Real Time Clock:– Counts seconds, minutes, hours, date ofthe month, month, day of the week, andyear with leap year

Seite 2 - DS1673 BLOCK DIAGRAM Figure 1

DS167310 of 18CU BIT TIMING Figure 63-WIRE SERIAL INTERFACECommunication with the DS1673 is accomplished through a simple 3-wire interface consisting

Seite 3 - SIGNAL DESCRIPTIONS

DS167311 of 18SINGLE-BYTE DATA TRANSFER Figure 7MULTIPLE-BYTE BURST TRANSFER Figure 8

Seite 4 - ADDRESS/COMMAND BYTE Figure 2

DS167312 of 18ABSOLUTE MAXIMUM RATINGS*Voltage on Any Pin Relative to Ground -0.3V to +7.0VOperating Temperature 0°C to 70°CStorage Temperature -55

Seite 5 - CLOCK, CALENDAR AND ALARM

DS167313 of 18DC ELECTRICAL CHARACTERISTICS (0°C to 70°C; VCC=3.0V ±=10%)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESInput Leakage ILI-1 +1µACS Leakage

Seite 6 - CONTROL REGISTER

DS167314 of 18AC ELECTRICAL CHARACTERISTICS (0°C to 70°C; VCC=5.0V ±=10%)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESData to Clock Setup tDC50 ns 8CLK to

Seite 7 - NONVOLATILE SRAM CONTROLLER

DS167315 of 18AC ELECTRICAL CHARACTERISTICS (0°C to 70°C; VCC=3.0V ±=10%)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESData to Clock Setup tDC150 ns 8CLK to

Seite 8 - MICROPROCESSOR MONITOR

DS167316 of 18TIMING DIAGRAM: READ DATA Figure 9TIMING DIAGRAM: WRITE DATA Figure 10

Seite 9 - ANALOG-TO-DIGITAL CONVERTER

DS167317 of 18PUSHBUTTON RESET Figure 11POWER-UP Figure 12POWER-DOWN Figure 13

Seite 10 - 3-WIRE SERIAL INTERFACE

DS167318 of 18NOTES:1. All voltages are referenced to ground.2. Logic 1 voltages are specified at VCC=3.0V, VOH=VCC for capacitive loads. Excludes R

Seite 11 - 11 of 18

DS16732 of 18Automatic backup and write protection of external SRAM is provided through the VCCO, CEOL , andCEOH pins. The backup energy source use

Seite 12 - =5.0V ±=10%)

DS16733 of 18SIGNAL DESCRIPTIONSVCC, GND - DC power is provided to the device on these pins. VCC is the +3.0 volt or +5.0 volt input.VBAT (Backup Pow

Seite 13 - =3.0V ±=10%)

DS16734 of 18X1, X2 - Connections for a standard 32.768 kHz quartz crystal. For greatest accuracy, the DS1673 mustbe used with a crystal that has a s

Seite 14

DS16735 of 18DS1673 ADDRESS MAP Figure 3CLOCK, CALENDAR AND ALARMThe time and calendar information is accessed by reading/writing the appropriate regi

Seite 15

DS16736 of 18TIME OF DAY ALARM BITS Table 1ALARM REGISTER MASK BITS (BIT 7)SECONDS MINUTES HOURS DAYS1 1 1 1 Alarm once per second.0 1 1 1 Alarm when

Seite 16 - 16 of 18

DS16737 of 18STATUS REGISTERBIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0CULOBAT00000IRQFCU (Conversion Update In Progress) - When this bit is a 1,

Seite 17 - PUSHBUTTON RESET Figure 11

DS16738 of 18EXTERNAL SRAM INTERFACE (WORD-WIDE) TO THE DS1673 Figure 4MICROPROCESSOR MONITORThe DS1673 monitors three vital conditions for a micropro

Seite 18 - 18 of 18

DS16739 of 18WATCHDOG TIME-OUT CONTROL Figure 5WATCHDOG REGISTERBIT 7 BIT 6 BIT 5 BIT 4 BIT 3 BIT 2 BIT 1 BIT 0000000TD1TD0WATCHDOG REGISTERTD1 TD0 WA

Kommentare zu diesen Handbüchern

Keine Kommentare