MAX8569A/MAX8569B
200mA Step-Up Converters in 6-Pin
SOT23 and TDFN
6 _______________________________________________________________________________________
Typical Operating Characteristics (continued)
(Circuit of Figure 2, V
OUT
= 3.3V, V
BATT
= +2V, T
A
= +25°C, circuit of Figure 1, T
A
= +25°C, unless otherwise noted.)
FUNCTION
11SHDN
Shutdown Input. Drive SHDN low to place the MAX8569 in shutdown mode. SHDN can be
used for a low-battery cutoff (1.228V threshold). See the Low-Battery Cutoff section for
details. Drive SHDN high for normal operation.
2 2 BATT
Battery Voltage Connection. Connect BATT to a 1.5V to 5.5V supply. Bypass BATT to GND
with a 10µF or larger ceramic capacitor.
3 3 GND Ground
44LX
Inductor Connection. Connect the switched side of the inductor to LX. During shutdown,
LX is connected to OUT.
5 5 OUT
Output Voltage. Bypass OUT to GND with a 10µF or larger ceramic capacitor. During
shutdown, OUT is connected to LX. OUT is also the bootstrapped supply input for the IC.
6 — FB
Feedback Input. Connect FB to the center tap of an external resistor-divider from OUT to
GND to set the output voltage. V
FB
regulates to 1.228V.
— 6 RST
Reset Output. RST is an open-drain output that goes high impedance when the output
voltage rises above 90% of the nominal regulation voltage. RST pulls low when the output
is below 90% of the nominal regulation voltage. RST is high impedance during shutdown.
——EP
Exposed Paddle (TDFN Package Only). Connect to the PC board ground plane for
increased thermal performance.
Kommentare zu diesen Handbüchern