Rainbow-electronics AT24C01 Bedienungsanleitung

1Features• Low Voltage and Standard Voltage Operation–2.7(VCC=2.7Vto5.5V)–1.8(VCC=1.8Vto5.5V)• Internally Organized 128 x 8• 2-Wire Serial Interface•

10AT24C010134E–SEEPR–08/02Note: For 2.7V devices used in the 4.5V to 5.5V range, please refer to performance values in the AC and DC Characteristics t

11AT24C010134E–SEEPR–08/02Packaging Information8P3 – PDIP2325 Orchard ParkwaySan Jose, CA 95131TITLEDRAWING NO.RREV. 8P3, 8-lead, 0.300" Wide B

12AT24C010134E–SEEPR–08/028S1 – JEDEC SOIC 2325 Orchard Parkway San Jose, CA 95131TITLEDRAWING NO.RREV. Note:10/10/018S1, 8-lead (0.150" Wide

13AT24C010134E–SEEPR–08/028A2 – TSSOP2325 Orchard ParkwaySan Jose, CA 95131TITLEDRAWING NO.RREV. 5/30/02COMMON DIMENSIONS(Unit of Measure = mm)SYMBO

Printed on recycled paper.0134E–SEEPR–08/02 xM© Atmel Corporation 2002.Atmel Corporation makes no warranty for the use of its products, other than tho

2AT24C010134E–SEEPR–08/02Block DiagramAbsolute Maximum Ratings*Operating Temperature... -55°Cto+125° C*NOTICE: Stresses

3AT24C010134E–SEEPR–08/02Pin Description SERIAL CLOCK (SCL): The SCL input is used to positive edge clock data into eachEEPROM device and negative edg

4AT24C010134E–SEEPR–08/02Note: 1. This parameter is characterized and is not 100% tested.AC CharacteristicsApplicable over recommended operating range

5AT24C010134E–SEEPR–08/02Device Operation CLOCK and DATA TRANSITIONS: The SDA pin is normally pulled high with an exter-nal device. Data on the SDA pi

6AT24C010134E–SEEPR–08/02Bus TimingSCL: Serial Clock, SDA: Serial Data I/OWrite Cycle TimingSCL: Serial Clock, SDA: Serial Data I/ONote: 1. The write

7AT24C010134E–SEEPR–08/02Data ValidityStart and Stop DefinitionOutput Acknowledge

8AT24C010134E–SEEPR–08/02Write Operations BYTE WRITE: Following a start condition, a write operation requires a 7-bit data wordaddress and a low write

9AT24C010134E–SEEPR–08/02Figure 1. Byte WriteFigure 2. Page WriteFigure 3. Byte ReadFigure 4. Sequential Read