Rainbow-electronics MAX107 Bedienungsanleitung Seite 5

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 21
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 4
MAX107
Dual, 6-Bit, 400Msps ADC with On-Chip,
Wideband Input Amplifier
_______________________________________________________________________________________ 5
Note 1: INL and DNL is measured using a sine-histogram method.
Note 2: Input offset is the voltage required to cause a transition between codes 0 and -1.
Note 3: Numbers provided are for DC-coupled case. The user has the choice of AC-coupling, in which case, the DC input voltage
level does not matter.
Note 4: The peak-to-peak input voltage required, causing a full-scale digitized output when using a trigonometric curve-fitting algo
rithm (e.g. FFT).
Note 5: Guaranteed by design and characterization.
Note 6: Common-mode rejection ratio is defined as the ratio of the change in the offset voltage to the change in the common-mode
voltage expressed in dB.
Note 7: Measured with analog power supplies tied to the same potential.
Note 8: Effective number of bits (ENOB) is computed from a curve-fit referenced to the theoretical full-scale range.
Note 9: The clock and input frequencies are chosen so that there are 2041 cycles in an 8,192-long record.
Note 10: Signal-to-noise-ratio (SNR) is measured both with the other channel idling and converting an out-of-phase signal.
The worst case number is presented. Harmonic distortion components two through five are excluded from the noise.
Note 11: Harmonic distortion components two through five are included in the total harmonic distortion specification.
Note 12: Both I and Q inputs are effectively tied together (e.g. driven by power splitter). Signal amplitude is -0.5dB FS at an input
frequency of f
IN
= 124.999 MHz.
Note 13: Measured with a differential probe, 1pF capacitance.
ELECTRICAL CHARACTERISTICS (continued)
(AV
CC
= AV
CC
I = AV
CC
Q = AV
CC
R = +5V, OV
CC
I = OV
CC
Q = +3.3V, AGND = AGNDI = AGNDQ = AGNDR = 0, OGNDI = OGNDQ
= 0, f
CLK
= 401.408MHz, C
L
= 1µF to AGND at REF, R
L
= 100 ±1% applied to digital LVDS outputs, T
A
= T
MIN
to T
MAX
, unless
otherwise noted. Typical values are at T
A
= +25°C)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
DREADY Duty Cycle (Notes 5, 13) 47 53 %
LVDS Output Rise-Time t
RDATA
20% to 80% (Notes 5, 13) 200 500 ps
LVDS Output Fall-Time t
FDATA
20% to 80% (Notes 5, 13) 200 500 ps
Any differential pair <65
LVDS Differential Skew t
SKEW1
Any tw o LV D S outp ut si g nal s excep t D RE AD Y <100
ps
DREADY Rise-Time t
RDREADY
20% to 80% (Notes 5, 13) 200 500 ps
DREADY Fall-Time t
FDREADY
20% to 80% (Notes 5, 13) 200 500 ps
Primary Port Pipeline Delay t
PDP
5
Clock
Cycles
Auxiliary Port Pipeline Delay t
PDA
6
Clock
Cycles
Seitenansicht 4
1 2 3 4 5 6 7 8 9 10 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare