Rainbow-electronics DS1670 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Computerhardware Rainbow-electronics DS1670 herunter. Rainbow Electronics DS1670 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 17
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
1 of 17 122800
FEATURES
Provides real time clock:
Counts seconds, minutes, hours, date of
the month, month, day of the week, and
year with leap year compensation valid up
to 2100
Power control circuitry supports system
power-on from day/time alarm
Microprocessor monitor:
Halts microprocessor during power fail
Automatically restarts microprocessor
after power failure
Monitors pushbutton for external override
Halts and resets an out of control
microprocessor
NV RAM control:
Automatic battery backup and write
protection to external SRAM
3-channel, 8-bit analog-to-digital converter
Simple 3-wire interface
3.3V operation
PIN ASSIGNMENT
Package Dimension Information can be found at:
http://www.dalsemi.com/datasheets/mechdwg.html
ORDERING INFORMATION
DS1670E 20-pin TSSOP
DS1670S 20-pin SOIC
DESCRIPTION
The Portable System Controller is a circuit, which incorporates many of the functions necessary for low
power portable products integrated into one chip. The DS1670 provides a Real Time Clock, NV RAM
controller, microprocessor monitor, and a 3-channel, 8-bit analog-to-digital converter. Communication
with the DS1670 is established through a simple 3-wire interface.
The Real Time Clock (RTC) provides seconds, minutes, hours, day, date, month, and year information
with leap year compensation. The RTC also provides an alarm interrupt. This interrupt works when the
DS1670 is powered by the system power supply or when in battery backup operation so the alarm can be
used to wake up a system that is powered down.
Automatic backup and write protection of an external SRAM is provided through the V
CCO
, CEOL , and
CEOH pins. The backup energy source used to power the RTC is also used to retain RAM data in the
absence of V
CC
through the V
CCO
pin. The chip-enable outputs to RAM ( CEOL and CEOH ) are
controlled during power transients to prevent data corruption.
1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
ST
V
CC
X1
X2
AIN0
AIN1
AIN2
RST
BLE
V
BAT
V
CCO
SCLK
I/O
CS
CEI
CEOL
CEOH
INT
GND
20-Pin TSSOP (4.4mm)
20-Pin SOIC (300 mil)
DS1670
Portable System Controlle
r
www.dalsemi.com
Seitenansicht 0
1 2 3 4 5 6 ... 16 17

Inhaltsverzeichnis

Seite 1 - Portable System Controlle

1 of 17 122800FEATURES Provides real time clock:− Counts seconds, minutes, hours, date ofthe month, month, day of the week, andyear with leap year

Seite 2 - SIGNAL DESCRIPTIONS

DS167010 of 17The Conversion Update In Progress (CU) bit in the Status Register indicates when the ADC Register canbe read. When this bit is a 1, an

Seite 3

DS167011 of 17Data transfers can occur 1 byte at a time or in multiple-byte burst mode. After CS is driven high anaddress is written to the DS1670.

Seite 4 - DS1670 ADDRESS MAP Figure 3

DS167012 of 17ABSOLUTE MAXIMUM RATINGS*Voltage on Any Pin Relative to Ground -0.3V to +6VOperating Temperature 0°C to 70°CStorage Temperature -55°C

Seite 5 - CONTROL REGISTER

DS167013 of 17DC ELECTRICAL CHARACTERISTICS (0°C to 70°C)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESInput Leakage ILI-1 +1µACS Leakage ILO150µA7Logic 1

Seite 6 - NONVOLATILE SRAM CONTROLLER

DS167014 of 17AC ELECTRICAL CHARACTERISTICS (0°C to 70°C; VCC = 3.3V ± 10%)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESData to Clock Setup tDC100 ns 8CLK

Seite 7

DS167015 of 17TIMING DIAGRAM: READ DATA Figure 9TIMING DIAGERAM: WRITE DATA Figure 10

Seite 8 - MICROPROCESSOR MONITOR

DS167016 of 17PUSHBUTTON RESET Figure 11POWER-UP Figure 12POWER-DOWN Figure 13RSTVOHtRSTPBDBPBDVPBRDVCCVCCTPtRPUVOHRSTVCCRSTVCCTPMAXVOLtRPDtFBVCCTP

Seite 9 - ANALOG-TO-DIGITAL CONVERTER

DS167017 of 17NOTES:1. All voltages are referenced to ground.2. Logic 1 voltages are specified at VCC =3.3V, VOH =VCC for capacitive loads. Excludes

Seite 10 - 3-WIRE SERIAL INTERFACE

DS16702 of 17The microprocessor monitor circuitry of the DS1670 provides three basic functions. First, a precisiontemperature-compensated reference a

Seite 11 - 11 of 17

DS16703 of 17CS (Chip Select) - The Chip Select signal must be asserted high during a read or a write forcommunication over the 3-wire serial interfac

Seite 12 - ABSOLUTE MAXIMUM RATINGS*

DS16704 of 17POWER-UP/POWER-DOWN CONSIDERATIONSThe DS1670 was designed to operate with a power supply of 3.3 volts. When 3.3 volts are applied within

Seite 13 - = 25°C)

DS16705 of 17CLOCK, CALENDAR AND ALARMThe time and calendar information is accessed by reading/writing the appropriate register bytes. Notethat some

Seite 14 - = 3.3V ± 10%)

DS16706 of 17AIS0-AIS1 (Analog Input Select) - These 2 bits are used to determine the analog input for the analog-to-digital conversion. Table 2 list

Seite 15 - 15 of 17

DS16707 of 17The DS1670 nonvolatilizes the external SRAM(s) by write protecting the SRAM(s) and by providing aback-up power supply in the absence of V

Seite 16 - POWER-DOWN Figure 13

DS16708 of 17EXTERNAL SRAM CHIP ENABLE Table 3CEIBHE BLECEOL CEOHFUNCTION0 0 0 0 0 Word Transfer0 0 1 1 0 Byte Transfer in upper half of databus (D15-

Seite 17 - 17 of 17

DS16709 of 17The third microprocessor monitoring function provided by the DS1670 is a watchdog timer. Thewatchdog timer function forces RST to the a

Kommentare zu diesen Handbüchern

Keine Kommentare