Rainbow-electronics ATmega64C1 Bedienungsanleitung Seite 176

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 366
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 175
176
7647A–AVR–02/08
ATmega32/64/M1/C1
5. Tsjw = (1 to 4) x Tscl = (SJW[1..0]+ 1) x Tscl
Notes: 1. The total number of Tscl (Time Quanta) in a bit time must be from 8 to 25.
2. PHS2[2..0] 2 is programmable to be
PHS1[2..0] and 1.
16.4.4 Fault Confinement
(c.f. Section 16.7 “Error Management” on page 181).
16.4.5 Overload Frame
An overload frame is sent by setting an overload request (OVRQ). After the next reception, the
CAN channel sends an overload frame in accordance with the CAN specification. A status or
flag is set (OVRF) as long as the overload frame is sent.
Figure 16-9. Overload Frame
16.5 Message Objects
The MOb is a CAN frame descriptor. It contains all information to handle a CAN frame. This
means that a MOb has been outlined to allow to describe a CAN message like an object. The set
of MObs is the front end part of the “mailbox” where the messages to send and/or to receive are
pre-defined as well as possible to decrease the work load of the software.
The MObs are independent but priority is given to the lower one in case of multi matching. The
operating modes are:
Disabled mode
Transmit mode
Receive mode
Automatic reply
Frame buffer receive mode
16.5.1 Number of MObs
This device has 6 MObs, they are numbered from 0 up to 5 (i=5).
Ident "A" Cmd Message Data "A" CRC InterframeA Ident "B"
Overload Frame
Overload Frame
RXCDAN
Setting OVRQ bit
OVFG bit
Resetting OVRQ bit
TXCDAN
OVRQ bit
Instructions
Seitenansicht 175
1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 365 366

Kommentare zu diesen Handbüchern

Keine Kommentare