
8
4979D–GPS–06/08
ATR0635P1
P20 G7 Digital I/O Configurable (PD) TIMEPULSE SCK2 SCK2
P21 E6 Digital I/O Configurable (PU) TXD2 TXD2
P22 D10 Digital I/O PU to VBAT18 RXD2 RXD2
P23 F8 Digital I/O Configurable (PU) GPSMODE7 SCK SCK
P24 H7 Digital I/O Configurable (PU) GPSMODE8 MOSI MOSI
P25 G5 Digital I/O Configurable (PD) NAADET0 MISO MISO
P26 B6 Digital I/O Configurable (PU) GPSMODE10 NSS NPCS0
P27 F7 Digital I/O Configurable (PU) GPSMODE11 NPCS1
P28 E7 Digital I/O OH
P29 D5 Digital I/O Configurable (PU) GPSMODE12 NPCS3
P30 G12 Digital I/O PD AGCOUT0 AGCOUT0
P31 C10 Digital I/O PU to VBAT18 RXD1 RXD1
PURF G4 Digital IN
PURF H4 Digital IN
PUXTO F4 Digital IN
RF D1 Analog IN
RF_ON F10 Digital OUT PD
SDI C4 Digital IN
SIGHI0 B8 Digital OUT
SIGLO0 B7 Digital OUT
TCK G9 Digital IN PU
TDI H10 Digital IN PU
TDO F9 Digital OUT
TEST D3 Analog IN
TMS G10 Digital IN PU
USB_DM D9 Digital I/O
USB_DP C9 Digital I/O
VBAT D12 Supply
VBAT18
(2)
C12 Supply
VBP G2 Supply
VBP G3 Supply
VBP H2 Supply
VBP H3 Supply
VCC1 C2 Supply
VCC2 E4 Supply
Table 3-1. ATR0635P1 Pinout (Continued)
Pin Name BGA 96 Pin Type
Pull Resistor
(Reset Value)
(1)
Firmware Label
PIO Bank A
IO
Notes: 1. PD = internal pull-down resistor, PU = internal pull-up resistor, OH = switched to Output High at reset
2. VBAT18 represent the internal power supply of the backup power domain, see section “Power Supply” on page 20.
3. VDD_USB is the supply voltage for following the USB pins: USB_DM and USB_DP, see section “Power Supply” on page
20. For operation of the USB interface, supply of 3.0V to 3.6V is required.
4. VDDIO is the supply voltage for the following GPIO pins: P1, P2, P8, P12, P14, P16, P17, P18, P19, P20, P21, P23, P24,
P25, P26, P27 and P29, see section “Power Supply” on page 20.
Kommentare zu diesen Handbüchern