Rainbow-electronics DS1667 Bedienungsanleitung Seite 1

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Computerhardware Rainbow-electronics DS1667 herunter. Rainbow Electronics DS1667 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 11
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
Copyright 1995 by Dallas Semiconductor Corporation.
All Rights Reserved. For important information regarding
patents and other intellectual property rights, please refer to
Dallas Semiconductor databooks.
DS1667
Digital Resistor with OP AMP
DS1667
021492 1/11
FEATURES
Two digitally controlled 256-position potentiometers
Serial port provides means for setting and reading
both potentiometers
Resistors can be connected in series to provide addi-
tional resolution
Default wiper position on power up is 50%
Resistive elements are temperature compensated to
+
20% end to end
Two high gain wide bandwidth operational amplifiers
Low power CMOS design
Applications include analog–to–digital and digital–to–
analog converters, variable oscillators, and variable
gain amplifiers
20–pin DIP package or optional 20–pin SOIC surface
mount package
Operating temperature range of 0°C to 70°C
Resistance Values
RESOLUTION -3 dB POINT
DS1667-10: 10K 39 ohms 1.1 MHz
DS1667-50: 50K 195 ohms 200 kHz
DS1667-100: 100K 390 ohms 100 kHz
PIN ASSIGNMENT
V
CC
OUT0
SOUT
W0
H0
L0
COUT
DQ
INVI
NINVI
NINV0
INV0
V
B
W1
H1
L1
RST
CLK
OUT1
GND
1
2
3
4
5
6
7
8
9
10
20
19
18
17
16
15
14
13
12
11
20-Pin DIP (300 Mil) and 20-Pin SOIC
PIN DESCRIPTION
V
CC
- +5 Volt Supply
GND - Ground
L0, L1 - Low End of Resistor
H0, H1 - High End of Resistor
W0, W1 - Wiper End of Resistor
V
B
- Substrate Bias and OP AMP
Negative Supply
SOUT - Wiper for Stacked
Configuration
RST
- Serial Port Reset Input
DQ - Serial Port Input/Output
CLK - Serial Port Clock Input
COUT - Cascade Serial Port Output
NINV0, NINVI - Noninverting OP AMP Input
INV0, INVI - Inverting OP AMP Input
OUT0, OUT1 - OP AMP Outputs
DESCRIPTION
The DS1667 is a dual–solid state potentiometer that is
adjustable by digitally selected resistive elements.
Each potentiometer is composed of 256 resistive ele-
ments. Between each resistive section of each poten-
tiometer are tap points accessible to the wiper. The po-
sition of the wiper on the resistive array is set by an 8–bit
register that controls which tap point is connected to the
wiper output. Each 8–bit register can be read or written
by sending or receiving data bits over a 3–wire serial
port. In addition, the resistors can be stacked such that
a single potentiometer of 512 sections results. When
two separate potentiometers are used, the resolution of
the DS1667 is equal to the resistance value divided by
256. When the potentiometers are stacked end to end,
the resistance value is doubled while the resolution re-
mains the same. The DS1667 also contains two high
gain wide bandwidth operational amplifiers. Each am-
plifier has both the inverting and non-inverting inputs
and the output available for user configuration. The op-
erational amplifiers can be paired with the resistive ele-
Seitenansicht 0
1 2 3 4 5 6 ... 10 11

Inhaltsverzeichnis

Seite 1 - Digital Resistor with OP AMP

Copyright 1995 by Dallas Semiconductor Corporation. All Rights Reserved. For important information regarding patents and other intellectual propert

Seite 2 - BLOCK DIAGRAM Figure 1

DS1667021492 10/11OPERATIONAL AMPLIFIER SECTIONAC ELECTRICAL CHARACTERISTICS (0°C to 70°C; VCC = 5.0V ± 10%)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESSl

Seite 3 - 021492 3/11

DS1667021492 11/11LOAD SCHEMATIC Figure 8+5 VOLTS50 pFD.U.T.680 Ω1.1K

Seite 4 - WRITING DATA Figure 2

DS1667021492 2/11ments to perform such functions as analog to digitalconversion, digital to analog conversion, variable gainamplifiers, and variable o

Seite 5 - DS1667 LINEARITY MEASUREMENTS

DS1667021492 3/11Information is written to and read from the wiper 0 andwiper 1 registers and the stack select bit via the 17-bitI/O shift register.

Seite 6

DS1667021492 4/11WRITING DATA Figure 2RSTDQCLKI/O SRWIPER 0 & 1STACK SELECTPREVIOUS VALUENEW VALUENEW CONTROL REG.+0, 1+0DON’T CAREDON’T CARE BIT

Seite 7

DS1667021492 5/11READING DATA Figure 4RSTCLKCONTROLREGISTERSCURRENT SETTINGSNOBIT 16COUTBIT 15 BIT 14 BIT 0 BIT 16CHANGESDS1667 LINEARITY MEASUREMENT

Seite 8 - °C to 70°C)

DS1667021492 6/11LINEARITY MEASUREMENT CONFIGURATION Figure 5+5V–5VHXPOTXRWX+–V0I0 = 0LXWXX=0 POT0X=1 POT1DS1667 ABSOLUTE AND RELATIVE LINEARITY Fig

Seite 9 - O,SOURCE

DS1667021492 7/11TIMING DIAGRAM: RESISTOR SECTION Figure 7RSTCLKDQ INPUTSCOUTtHHTtWtHLTtWtHtHtSUtSUtPLH

Seite 10 - °C to 70°C; V

DS1667021492 8/11ABSOLUTE MAXIMUM RATINGS*Voltage on Any Pin Relative to Ground (VB = GND) –0.5V to +7.0VVoltage on Resistor Pins when VB = -5.5V -5.5

Seite 11 - LOAD SCHEMATIC Figure 8

DS1667021492 9/11CAPACITANCE (tA = 25°C)PARAMETER SYMBOL MIN TYP MAX UNITS NOTESInput Capacitance CIN5 pFOutput Capacitance COUT7 pFAC ELECTRICAL CHA

Kommentare zu diesen Handbüchern

Keine Kommentare