Rainbow-electronics Atmega169L Bedienungsanleitung PDF herunterladen (Seite 294)

294

ATmega169V/L

2514A–AVR–08/02

gram counter after each word is read. Note that Capture-DR comes before the

shift-DR state. Hence, the first byte which is shifted out contains valid data.

6. Enter JTAG instruction PROG_COMMANDS.

7. Repeat steps 3 to 6 until all data have been read.

Programming the EEPROM 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable EEPROM write using programming instruction 4a.

3. Load address High byte using programming instruction 4b.

4. Load address Low byte using programming instruction 4c.

5. Load data using programming instructions 4d and 4e.

6. Repeat steps 4 and 5 for all data bytes in the page.

7. Write the data using programming instruction 4f.

8. Poll for EEPROM write complete using programming instruction 4g, or wait for

WLRH

(refer to Table 128 on page 278).

9. Repeat steps 3 to 8 until all data have been programmed.

Note that the PROG_PAGELOAD instruction can not be used when programming the

EEPROM.

Reading the EEPROM 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable EEPROM read using programming instruction 5a.

3. Load address using programming instructions 5b and 5c.

4. Read data using programming instruction 5d.

5. Repeat steps 3 and 4 until all data have been read.

Note that the PROG_PAGEREAD instruction can not be used when reading the

EEPROM.

Programming the Fuses 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Fuse write using programming instruction 6a.

3. Load data high byte using programming instructions 6b. A bit value of “0” will

program the corresponding fuse, a “1” will unprogram the fuse.

4. Write Fuse High byte using programming instruction 6c.

5. Poll for Fuse write complete using programming instruction 6d, or wait for t

WLRH

(refer to Table 128 on page 278).

6. Load data low byte using programming instructions 6e. A “0” will program the

fuse, a “1” will unprogram the fuse.

7. Write Fuse low byte using programming instruction 6f.

8. Poll for Fuse write complete using programming instruction 6g, or wait for t

WLRH

(refer to Table 128 on page 278).

Programming the Lock Bits 1. Enter JTAG instruction PROG_COMMANDS.

2. Enable Lock bit write using programming instruction 7a.

3. Load data using programming instructions 7b. A bit value of “0” will program the

corresponding lock bit, a “1” will leave the lock bit unchanged.

4. Write Lock bits using programming instruction 7c.

5. Poll for Lock bit write complete using programming instruction 7d, or wait for

WLRH

(refer to Table 128 on page 278).

1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 316 317

Kommentare zu diesen Handbüchern

Keine Kommentare

Rainbow-electronics Atmega169L Bedienungsanleitung Seite 294

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Sensoren Rainbow-electronics Atmega169L

Related products and manuals for Unknown LG 29FU1RLX-ZG