Rainbow-electronics ATtiny861_V Bedienungsanleitung PDF herunterladen (Seite 83)

2588B–AVR–11/06

ATtiny261/461/861

The following code examples show how to do an atomic write of the TCNT0H/L register con-

tents. Writing any of the OCR0A/B registers can be done by using the same principle.

Note: 1. The example code assumes that the part specific header file is included.

For I/O registers located in extended I/O map, “IN”, “OUT”, “SBIS”, “SBIC”, “CBI”, and “SBI”

instructions must be replaced with instructions that allow access to extended I/O. Typically

“LDS” and “STS” combined with “SBRS”, “SBRC”, “SBR”, and “CBR”.

The assembly code example requires that the r17:r16 register pair contains the value to be writ-

ten to TCNT0H/L.

14.9.1 Reusing the temporary high byte register

If writing to more than one 16-bit register where the high byte is the same for all registers written,

then the high byte only needs to be written once. However, note that the same rule of atomic

operation described previously also applies in this case.

Assembly Code Example

TIM0_WriteTCNT0:

; Save global interrupt flag

in r18,SREG

; Disable interrupts

cli

; Set TCNT0 to r17:r16

out TCNT0H,r17

out TCNT0L,r16

; Restore global interrupt flag

out SREG,r18

ret

C Code Example

void TIM0_WriteTCNT0( unsigned int i )

{

unsigned char sreg;

/* Save global interrupt flag */

sreg = SREG;

/* Disable interrupts */

_CLI();

/* Set TCNT0 to i */

TCNT0H = (i >> 8);

TCNT0L = (unsigned char)i;

/* Restore global interrupt flag */

SREG = sreg;

}

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 235 236

Keine Kommentare

Rainbow-electronics ATtiny861_V Bedienungsanleitung Seite 83