Rainbow-electronics ATmega128RFA1 Bedienungsanleitung Seite 469

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 524
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 468
469
8266A-MCU Wireless-12/09
ATmega128RFA1
Table 31-11. Pin Values Used to Enter Programming Mode
Pin Symbol Value
PAGEL Prog_enable[3] 0
XA1 Prog_enable[2] 0
XA0 Prog_enable[1] 0
BS1 Prog_enable[0] 0
Table 31-12. XA1 and XA0 Encoding
XA1 XA0 Action when CLKI is Pulsed
0 0
Load Flash or EEPROM Address (High or low address byte
determined by BS2 and BS1).
0 1
Load Data (High or Low data byte for Flash determined by
BS1).
1 0 Load Command.
1 1 No Action, Idle.
Table 31-13. Command Byte Bit Encoding
Command Byte Command Executed
1000 0000 Chip Erase
0100 0000 Write Fuse bits
0010 0000 Write Lock bits
0001 0000 Write Flash
0001 0001 Write EEPROM
0000 1000 Read Signature bytes and Calibration byte
0000 0100 Read Fuse and Lock bits
0000 0010 Read Flash
0000 0011 Read EEPROM
31.7 Parallel Programming
Pulses of CLKI and in the following command sequences are assumed to be at least
250 ns wide unless otherwise noted.
31.7.1 Enter Programming Mode
The following algorithm puts the device in parallel programming mode:
1. Apply 3.3V between DEVDD and DVSS.
2. Set RSTN to 0 and TST to 0.
3. Set the Prog_enable pins listed in Table 31-11 above to “0000” and wait at least
100ns.
4. Set TST to 1. TST can be set high any time before but not after the rising edge of
RSTN (t
TSTRNH
).
5. Set RSTN to 1. Any activity on Prog_enable pins within 100 ns after RSTN is set to 1
will cause the device to fail entering programming mode.
6. Wait at least 50 µs before sending a command.
Seitenansicht 468
1 2 ... 464 465 466 467 468 469 470 471 472 473 474 ... 523 524

Kommentare zu diesen Handbüchern

Keine Kommentare